Hi everyone!
I’m curious to know which slicer you guys use.
I’ve been using the Creality slicer, but it seems like it pretty consistently crashes, and I’ve tried Cura but the print seemed stringy despite using the same settings.
How are Orca or Prusa?
Prusa and SuperSlicer.
SuperSlicer, nightly builds from GitHub.
Nightly builds with commits that happen sporadically every few months it seems 😭.
That said, it looks like some action happened since my last build. I’ll have to see if the cone slicing thing is fixed…
SLA: Lychee free version bc fuck renting licenses
FDM: prusa slicer bc open source ftw
Prusa slicer, partially because I have a mk3s+ but also because I tried to use cura many times but always several minutes into using it, my entire laptop just shuts off, like the power was pulled, no logs written to disk, no error message. It’s the only program to do that and I can’t even report an issue because there’s no logs I can submit. I assume it’s related to taxing my GPU in a way that causes a power related fault.
Cura and my self programmed vase mode slicer
Cura. Works for me.
I used Cura for a few years, then I tried Prusa and my print quality dramatically improved for reasons I have not figured out.
Prusaslicer. For resin I combine it with UVtools
Whichever one works. I switch between Cura and PS. I’m not skilled enough to figure out the differences. I make small adjustments here and there, but IDK what I’m doing. My last print had over extrusion on the top surface, but not the walls, so I switched from Cura to PS and it works now.
I’ve only used cura (no particular reason, just what was shown to me and I now know how to use it
However, I’ve heard good things about both prusa and klipper
Klipper is not a slicer. It’s a replacement firmware for the printer.