I added some swear words as contact names, this is one way to get around the fucking censorship

Does mean that the unvaccinated anti-vaxers will keep away from the vaccinated??

At least one cat 6 ethernet in each room. Multiple outlets in any media room. One of my old houses had speaker jacks in each corner of the room which was a godsend when setting up surround sound for a home cinema setup.

Copse was my initial thought, but there is also the word Spinney.

https://www.dictionary.com/browse/spinney

Here’s a Piped link to the video in the article:

https://piped.video/watch?v=83ShvgtyFAg

Surprisingly this chair has come out highly in reviews when compared to 4 figure chairs. I have it and can say it is very comfortable. It’s not going to be the best of the best, however if your budget doesn’t stretch to more than mid-3 figures this could be a good alternative.

https://www.ikea.com/gb/en/p/markus-office-chair-vissle-dark-grey-30261152/

https://www.shortlist.com/lists/best-office-chairs-401080

I’m pretty sure I’d be ok in multiple realities

Nice! Maybe I should post my experiences from turning 40 onwards!

I also found a huge difference between filaments. Creality was terrible for me, Reflow is great

This really summarises the passive aggressive level you get to with a 3D printer: “Lift off the bed now you little fucker!”

So a combination of three changes finally got me back the correct result.

1. Changed the nozzle for a brand new one, that helped a lot but still had a fee issues.
2. Remeasured my extrusion amount and recalibrated the e-steps, they had gone quite a way out.
3. Reduced the temp by 10°C apart from the first layer.

Thanks for your help!

So a combination of three changes finally got me back the correct result.

1. Changed the nozzle for a brand new one, that helped a lot but still had a fee issues.
2. Remeasured my extrusion amount and recalibrated the e-steps, they had gone quite a way out.
3. Reduced the temp by 10°C apart from the first layer.

Thanks for your help!

I will check that, I hope its that as that would be an easy fix. Also I only use matte filament.

When you say pressure of the z-axis, do you know what they meant exactly? Not sure it could be temp as it’s the same, however I did change the part cooling fan in case that was faulty and the material wasn’t cooling fast enough

Dead man’s bones

Aha! Thank you!

Accurate

I’m guessing imgur was the wrong choice…