https://i.imgur.com/yzJg1ne.jpg

https://i.imgur.com/IgVP7Fj.jpg

Any ideas on this new issue only affecting one of my printers, only seems to be on the bottom layers of a base mode print. The layers that are not done as one continuous spiral. Photos are before and after, ignore the banding on the before! (Thats another issue I have fixed)

Can’t figure this one out, driving me mad as I have orders to fulfil

Solved:

So a combination of three changes finally got me back the correct result.

  1. Changed the nozzle for a brand new one, that helped a lot but still had a fee issues.
  2. Remeasured my extrusion amount and recalibrated the e-steps, they had gone quite a way out.
  3. Reduced the temp by 10°C apart from the first layer.
  • HerrBeter@lemmy.worldEnglish
    2·
    2 years ago

    I only know that in an other group they said it’s the pressure of the Z-axis or too high temperature

    • Prismo@lemmy.worldOPEnglish
      2·
      2 years ago

      When you say pressure of the z-axis, do you know what they meant exactly? Not sure it could be temp as it’s the same, however I did change the part cooling fan in case that was faulty and the material wasn’t cooling fast enough

    • Prismo@lemmy.worldOPEnglish
      1·
      2 years ago

      So a combination of three changes finally got me back the correct result.

      1. Changed the nozzle for a brand new one, that helped a lot but still had a fee issues.
      2. Remeasured my extrusion amount and recalibrated the e-steps, they had gone quite a way out.
      3. Reduced the temp by 10°C apart from the first layer.

      Thanks for your help!