Actual poster from 1917 that made me laugh. A lot.
Also, those motherfuckers are measuring the weight of those balls in kilograms, aren’t they?
Actual poster from 1917 that made me laugh. A lot.
Also, those motherfuckers are measuring the weight of those balls in kilograms, aren’t they?
All I can say is that the metric system was predominantly taught in my American school experience, with US units mainly limited to math class. The only thing that sucked about using metric in science class is the short unit we had where we needed to convert measurements between metric and US, which I think was arguably the point.
It’s corporations, really, that seem to insist on having their products and tools still defaulting to US customary units, and I can’t fathom why. Even when you go abroad and try to buy a TV, they’re all still labeled in inches, which boggles my mind.
I am no corporate fan, but this one is not on them. They already sell the same products in metric everywhere else. If the US switched to metric, most corporations would be able to switch overnight.
Not likely, the production lines used to service other countries are probably not the same used to supply the US.
New equipment would have to be obtained, new processes developed based on differences with regional suppliers, different regulatory standards on the production process would have to be adhered to, and they’d lose out on the generations of compatibility with older standards that they are intent keeping as cost saving measures.
Overnight is a stretch, but could they switch given enough time? Almost certainly. But it’s a major unnecessary expense that doesn’t immediately benefit shareholders.
I doubt the corporations care in any deep way, same as with anything else. It’s just sort of a chicken and egg thing. They’ll resist change as long as resisting is cost-effective, but that very resistance slows adoption. Still, they will likely shrug and adapt if it becomes obvious that people prefer metric, or even simply stop caring.
Did you go to school in the 70s or 80s? I don’t think it’s like that anymore.
Probably depends on state. I went to high school in Washington state, just about a decade ago, and we were taught SI units in most science classes. Unit conversion was almost always one of the first lessons we had. Chemistry specifically made us learn sig figs, which is much easier to use with SI units, and made me wish we used them everywhere.
That’s probably what it is. I didn’t go to school in the US but my kids went to school in Ohio and my impression was that metric was not the primary system of units used in education, though it was taught.
The argument I hear most often from people defending the US customary units is that the units are more intuitive. For example, an inch is about the size of a thumb, or 0 degrees is fucking cold and 100 is fucking hot.
On the whole, people seem receptive to metric, but don’t want the hassle or cost to convert. They seem content to use metric where it’s important (science, military) and keep the old ways elsewhere.
I currently with in healthcare research and almost everything not patient facing is done in metric, but there are still conversions going on everywhere, leading to data problems that are hard to correct later. People used to thinking in ounces putting those where grams were supposed to go, and so on.
90’s-00’s in Massachusetts