I liked a few of the VSOs that were posted earlier and wanted to share two of my more recent creations.
This mount screws into an exposed 2x4 and lets me get my Synology DS418, its power brick, and UPS (APC BE600M1) off a table and into a lower dust area of my basement.
I’ll upload the STLs to printables if anyone is interested, but be warned that the parts are fairly large.
In the spirit of showing parts under unflattering lighting, here’s (nearly) the same angle with a different light source.
What kind of filament is that printed with and are you concerned about it failing over time? Especially if there’s spinning disks in there I’d be paranoid as hell about it falling.
This scares the hell out of me. Too much risk of damage. Heat, weight, and time.
There’s basically no heat involved. It sounds like you’re worried about creap, which is totally fair and something to be aware of. The parts are printed out of ASA and are very overbuilt, so there shouldn’t be any cause for concern.
Creap video: https://youtu.be/88pk2cNOeGE?si=_JxBtYyYitBEin2Y
It looks beefy enough to me
I’d print it but using ABS
It’s ASA, it’ll be fine :)
Yeah. That’ll be good.
This man has never heard of 3d2a :P
It’s printed out of ASA, which basically doesn’t creap. It’s also wayyyy overbuilt for the amount of weight it’s supporting. I’m not at all worried about it failing over time.
As long as it’s not pla. That’s a ticking time bomb.
It’s ASA, should be more than fine :)