I want to buy a 3D printer for about 200-250€ but I’m unsure which one to get. There are printers that a lot of people recommend but others say they’re a piece of garbage.

The ones I found so far are these:

  • Creality Ender 3 V3 SE - 182,94€
  • Anycubic Kobra 2 Neo - 199,00€
  • Sovol SV06 - 239,00€

There’s also the open source firmware Klipper, which a lot people recommend but from what I understand, you need a Raspberry Pi for that. I do have a Pi 4 that I was planning to sell that I could use for that instead.

Would be great if some of you who know more than me could help me decide what to get.

  • lgmjon64@lemmy.worldEnglish
    2·
    9 months ago

    I used to have an Ender. It was great, very few problems. Ended up needing to sell it while I traveled for residency, then ended up getting a soval. I like it even more. Set up was super easy, prints are great. Only issue I’ve had was needing to replace the hot end because I boogered it up and completely encased it in plastic. On the plus side, changing the hot end was fast and easy.

    • Stampela@startrek.websiteEnglish
      1·
      9 months ago

      Seconding this. I had a rock solid Ender 3 since 2018 that got a few upgrades (btt 32 bit silent board, geared extruder, abl, couple of printed add ons) but never really needed any maintenance, recently upgraded to a Sovol SV07 Plus (big SV07, mechanically similar to the SV06) and hot damn! It’s a beast. Not only it goes stupid fast, can reach higher temperatures, heats faster… but it’s great out of the box and it prints TPU like nothing. Really, I tested it without changing anything and it worked fine. Downsides are that I got used to Octoprint and it can’t be used here, but Klipper is a decent replacement. Now, the ugly bit about that: it’s running on a really cheap board and an oddly customized os. You don’t notice any of that normally so that’s a plus, HOWEVER if like me you have a Spaghetti Detective/Obico account things change. There’s some copy paste to do via ssh, then the webcam struggles to hit 15 fps and whatever you do DON’T push any update button! Those wrecked everything. Not a fun few hours when I tried to figure out how to fix it.

      Anyway the SV06 mentioned by OP is with Marlin rather than Klipper so none of the warnings apply :D