I do woodworking a bit too, but I normally just do the slanty ruler/tape trick to divide any straight parallel face into n equal lengths.
I hate all forms of mental arithmetic; I also avoid measuring as much as possible too. Maybe that’s why everything i make is so shit.
I guess if you’re mass producing things you can’t just manually mark off each and every part though - but even then I’d probably want to work to a template rather than to measure.
A template or jig, yeah. If I’ve got more than one part to make, especially if they need to match in some substantial way, I set up a stop of some kind.
At some point I may attempt to build a project to a scored storey stick rather than to measurements, but on the other hand I may not.
I do woodworking a bit too, but I normally just do the slanty ruler/tape trick to divide any straight parallel face into n equal lengths. I hate all forms of mental arithmetic; I also avoid measuring as much as possible too. Maybe that’s why everything i make is so shit.
I guess if you’re mass producing things you can’t just manually mark off each and every part though - but even then I’d probably want to work to a template rather than to measure.
A template or jig, yeah. If I’ve got more than one part to make, especially if they need to match in some substantial way, I set up a stop of some kind.
At some point I may attempt to build a project to a scored storey stick rather than to measurements, but on the other hand I may not.