Easiest and least expensive are a little different, so I’ll talk briefly about both.
The easiest is to go on Etsy and search for Meshtastic. You will find plenty of people who will build you a ready-to-go unit, both individual radios and solar-powered repeaters. (If you plan to put your repeater somewhere with power you can use any radio as a repeater, just put a good antenna on it.) Pre-built units start at around $60 and can go up into the hundreds, but $60 to $90 will get you a great personal radio.
The least expensive is to order a kit from one of the many companies that sell them. If the kit does not come with a case, check Etsy for cases that match your kit. Most kits do not require soldering, you just have to plug in various cables and connectors, then fit everything into the case. Some actually come fully assembled. This approach generally costs somewhere between half and two-thirds of what a pre-built setup will run. Kits start as low as $10, although most or $20 to $40, and cases are mostly $20 to $35.
One of the harder parts is to figure out which radio kit you want, but there are just two major types. Those built around the ESP32 processor tend to be a little less expensive and offer the option of WiFi, but they have a much shorter battery life. Those built around the nRF52 processor cost a little more, do not offer WiFi, but have nearly 10 times the battery life. WiFi is only used in a few specific cases, usually by repeaters and not personal units, so you may well not need it. Battery life is not usually an issue for personal radios, since nearly all of them will go for a full day between charges, but sometimes you may want more than that. Stand-alone repeaters that run off solar panels are almost all based on the nRF52 because of the battery life.
The most common starter radios are based on the Heltec V3 kit, which is based on the ESP32. It has been around a long time, it is relatively inexpensive, and it can do pretty much everything. The only downside is battery life, which may or may not matter to you. Unless that’s a concern, you can’t go wrong with a V3. My personal favorite is the T114 kit, also from Heltec, which is based on the nRF52. It is much like the V3, but without WiFi and with much better battery life.
I would wait until you’ve played with a personal radio before buying a repeater. Every Meshtastic radio acts as a repeater, so you don’t necessarily need a dedicated repeated. Find out how many nodes are in your area and what kind of coverage you get. If there aren’t many nodes, or distance is limited, you can consider a dedicated repeater.
Basically, a repeater is just a node with a good location that’s put in a good location, up as high as possible. Because Meshtastic radios use very little power, it is practical to make completely self-sufficient solar repeater units that never require charging. You can put one of those on your roof, up in a tree, or on top of a nearby hill or mountain, without having to worry about regularly climbing back up there.
I strongly recommend that you go to meshtastic.org and read through the Getting Started documentation. It provides a lot more detail (and less personal opinion). And check out the Meshtastic communities on Lemmy. Have fun!
Thank you for the detailed reply! Yeah I realize now Mestastic.Org has everything I need.
Planning to prolly get:
A rak wireless kit for a local repeater on my roof powered via PoE, and then a TTGO TEcho for my personal device.
I know that I should just get the latter and play with it first, but I live high on a hill with a great vantage point of the city so feels like a disservice to the community if I don’t also host a repeater.
One thing I’m curious about, is if I use it via poe, can I also send messages via the repeater? I.e. locally from my network initiate a message through my repeater?
I would want it in repeater mode so it would forward any message even ones I don’t have the encryption key for.
How do I do this? Shats the easiest way to get started?
Both a personal device and a repeater on my house
Easiest and least expensive are a little different, so I’ll talk briefly about both.
The easiest is to go on Etsy and search for Meshtastic. You will find plenty of people who will build you a ready-to-go unit, both individual radios and solar-powered repeaters. (If you plan to put your repeater somewhere with power you can use any radio as a repeater, just put a good antenna on it.) Pre-built units start at around $60 and can go up into the hundreds, but $60 to $90 will get you a great personal radio.
The least expensive is to order a kit from one of the many companies that sell them. If the kit does not come with a case, check Etsy for cases that match your kit. Most kits do not require soldering, you just have to plug in various cables and connectors, then fit everything into the case. Some actually come fully assembled. This approach generally costs somewhere between half and two-thirds of what a pre-built setup will run. Kits start as low as $10, although most or $20 to $40, and cases are mostly $20 to $35.
One of the harder parts is to figure out which radio kit you want, but there are just two major types. Those built around the ESP32 processor tend to be a little less expensive and offer the option of WiFi, but they have a much shorter battery life. Those built around the nRF52 processor cost a little more, do not offer WiFi, but have nearly 10 times the battery life. WiFi is only used in a few specific cases, usually by repeaters and not personal units, so you may well not need it. Battery life is not usually an issue for personal radios, since nearly all of them will go for a full day between charges, but sometimes you may want more than that. Stand-alone repeaters that run off solar panels are almost all based on the nRF52 because of the battery life.
The most common starter radios are based on the Heltec V3 kit, which is based on the ESP32. It has been around a long time, it is relatively inexpensive, and it can do pretty much everything. The only downside is battery life, which may or may not matter to you. Unless that’s a concern, you can’t go wrong with a V3. My personal favorite is the T114 kit, also from Heltec, which is based on the nRF52. It is much like the V3, but without WiFi and with much better battery life.
I would wait until you’ve played with a personal radio before buying a repeater. Every Meshtastic radio acts as a repeater, so you don’t necessarily need a dedicated repeated. Find out how many nodes are in your area and what kind of coverage you get. If there aren’t many nodes, or distance is limited, you can consider a dedicated repeater.
Basically, a repeater is just a node with a good location that’s put in a good location, up as high as possible. Because Meshtastic radios use very little power, it is practical to make completely self-sufficient solar repeater units that never require charging. You can put one of those on your roof, up in a tree, or on top of a nearby hill or mountain, without having to worry about regularly climbing back up there.
I strongly recommend that you go to meshtastic.org and read through the Getting Started documentation. It provides a lot more detail (and less personal opinion). And check out the Meshtastic communities on Lemmy. Have fun!
Save worthy post. Not the person who asked, but thanks for the extremely detailed response!
Thank you for the detailed reply! Yeah I realize now Mestastic.Org has everything I need.
Planning to prolly get:
A rak wireless kit for a local repeater on my roof powered via PoE, and then a TTGO TEcho for my personal device.
I know that I should just get the latter and play with it first, but I live high on a hill with a great vantage point of the city so feels like a disservice to the community if I don’t also host a repeater.
One thing I’m curious about, is if I use it via poe, can I also send messages via the repeater? I.e. locally from my network initiate a message through my repeater?
I would want it in repeater mode so it would forward any message even ones I don’t have the encryption key for.