Thanks for the share. That’s interesting and I understand the niche needs for developping countries. Especially when you don’t have a strong control on what you get as pipes.

What I find interesting is the way they choose to make it watertight : “100% infill was leveraged to ensure all components were watertight, while extrusion flow was increased by 5-15% to prevent layer gaps.”

I would fear the bacterias. Bacterias love temperatures between 40°C and 50°C. I don’t know about the typical temperatures of Food Dehydrators. But filament dehydrators are targeting these temperatures.

I am interested in it. What are you making for scubadiving that needs to be waterproof?

This is depressing.

The next step when the company is unable to produce any value anymore, it’s to become a patent troll.

Ooooh OK. I feel stupid.

Is this a pun ? I don’t get it.

Can you try to change the geometry so that the different bridges are not consecutive in their corners ? It looks like the slicer is just trying to make one big bridge (in one direction) instead of 4 bridges in 4 directions.

Yes. https://en.m.wikipedia.org/wiki/Polar_coordinate_system

Since this curve is cyclical, you can do it [-infinity ; +infinity] and it’s the same curve again and again.

What the actual fuck.

I love the musics. After finishing the game, I played the main theme in my car again and again and again.

Nice !

I would go with wood filament.

Oh crap. You are right. Now I feel angry if this is fake data.

I was maintaining a custom autoexec.bat just for TIE Fighter.

I just measured it and the overhang behind is half the bed and half the infamous cable. You need around 60cm between the front feet and the wall behind, for the cable not to be torn when the bed is all the way to the back.

The bed goes back and forth. On the back, you need the place since there is the infamous cable that should not be torn. On the front, the bed can go over the void. There is no need for a 70 cm large table, maybe 50cm with overhang.

It’s a mess. I have the A1 with AMS and it takes way more space than I wanted. The coreX with AMS are way more compact.

Edit.
Wide 80cm (with the poop chute on the left and the AMS on the right) Depth 70cm (with all the cables and the bed going back and forth) Height 60cm with the top roll

I would like to get one for our club but I can’t understand the wide variety of prices. $150 ? $500 ? $2000 ? $10000 ? $75000!! ? What’s the cheapest that is not a pain to use ?

Sexy

What slicer is it ? I will check if it is possible to set no purge at all in BambuStudio - since I have an AMS lite.

It looks feasible with a purge multiplier set to 0. https://forum.bambulab.com/t/setting-an-unbeatable-record-no-flush-at-all/51052/4