I finally finished model 7 (Buggy) from 3dsets. It was fun to build, but mistake to take it in forest (one screw loose near one rear wheel).

  • UserNotFound@lemmy.worldOPEnglish
    3·
    1 year ago

    I see, thanks for explain.

    Driveline is no need to lubricate, because it’s belt drive system(at least in Model 7). Parts fit well, bearings, belts etc (although, that depends on how well calibrated is your printer). I think that system is strong enough. I built it with brushless motor and it’s wild.

    Only challenging parts were ball joints. I had problems to fit them in place, but I found a way.

      • UserNotFound@lemmy.worldOPEnglish
        2·
        1 year ago
        • PLA:
        • Prusament Lipstick Red (body)
        • Polyterra Charcoal Black (chassis)
        • Polyterra Fossil grey (inside)
        • Filament PM(Czech brand) graphite black (seats)
        • Filament PM white
        • Filament PM Pearl Red (cage)
        • Fillamentum Clear (for lights)
        • ASA:
        • Prusament Lipstick Red (for few parts)