I’m looking to buy an intermediate level printer to upgrade from a MK2, and I’m deciding between a P1S vs a MK4.
I have never considered getting anything other than a Prusa, since I’ve had such good experiences using mine, however I heard that recently they’ve switched away from their open source model(?)
That and being made in the EU was the main differentiating factor for me, however I do hear really good things about Bambu printers.
Does anyone have experience with either?
Edit: Found a lot of the information I was looking for here: https://lemmy.world/post/9500502
It kinda blows my mind that the bed leveling calibration is still doing that. I have a modified MK3S printer profile setup in Prusa slicer to keep the temperature below the oozing point (usually 180C works) until after the process because of this.
The nozzle temp is 170 by default and it does it.
That’s odd. Could be something with the filament maybe?
Just edit your start g-code to use a colder temperature. I don’t have a Mk4, just a mk3s+. I use a temperature of 160C for the start routine to prevent any dribbles from happening.