rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish · edit-21 year agostringing suggestions?message-squaremessage-square28fedilinkarrow-up117arrow-down10file-text
arrow-up117arrow-down1message-squarestringing suggestions?rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish · edit-21 year agomessage-square28fedilinkfile-text
minus-squareimgonnatrythis@lemm.eelinkfedilinkEnglisharrow-up1·1 year agoOk, so you don’t torch the print directly? Just heating up a screwdriver any lighter should work right?
minus-squareGorroth@lemmy.worldlinkfedilinkEnglisharrow-up1·1 year agoNo, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
minus-squareimgonnatrythis@lemm.eelinkfedilinkEnglisharrow-up2·1 year agoOk. I’m going to give this a try thx.
Ok, so you don’t torch the print directly? Just heating up a screwdriver any lighter should work right?
No, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
Ok. I’m going to give this a try thx.